New Question
 
 
PRTG Network Monitor

Intuitive to Use.
Easy to manage.

200.000 administrators have chosen PRTG to monitor their network. Find out how you can reduce cost, increase QoS and ease planning, as well.

Free PRTG
Download >>

 

What is this?

This knowledgebase contains questions and answers about PRTG Network Monitor and network monitoring in general. You are invited to get involved by asking and answering questions!

Learn more

 

Top Tags


View all Tags


Services Monitoring

Votes:

0

Your Vote:

Up

Down

How to monitor a particular service of Linux and windows server

Linux - HA proxy, NFS, Apache & MySQL
Windows - Apache

linux-services snmp windows-services

Created on Jul 9, 2019 9:02:39 AM by  admin (0) 1

Last change on Jul 9, 2019 10:27:08 AM by  Sebastian Kniege [Paessler Support]



3 Replies

Votes:

0

Your Vote:

Up

Down

Hi there,

Thank you very much for your contact.

For Windows based service monitoring, there are two native and built-in sensors in PRTG.
The SNMP Windows Service Sensor and the WMI Service Sensor.

For monitoring processes in Linux, please refer to this knowledge base article. If this approach does not suit your requirements, you could consider using a self-written SSH Custom Script Sensor.

Best,
Sebastian

Created on Jul 9, 2019 10:40:43 AM by  Sebastian Kniege [Paessler Support]



Votes:

0

Your Vote:

Up

Down

For adding SNMP Windows Service Sensor what condition should be apply ??

Created on Jul 9, 2019 11:56:16 AM by  admin (0) 1



Votes:

0

Your Vote:

Up

Down

Hi,

Did you already check the sensor's manual and especially the remarks section?

Important to know is that you need to enable the SNMP service first, before being able to monitor it via SNMP. Please follow our blog article how to setup SNMP on a Windows client:
https://www.paessler.com/blog/how-to-enable-snmp-on-your-operating-system

Afterwards, it is also necessary to configure the incoming SNMP communication for PRTG's point of view properly. To do so, please open the "Settings" tab of the device that should has the SNMP sensors and configure the corresponding settings at "Credentials for SNMP devices".

Best,
Sebastian

Created on Jul 9, 2019 12:28:31 PM by  Sebastian Kniege [Paessler Support]



Please log in or register to enter your reply.


Disclaimer: The information in the Paessler Knowledge Base comes without warranty of any kind. Use at your own risk. Before applying any instructions please exercise proper system administrator housekeeping. You must make sure that a proper backup of all your data is available.